user manual

AT-TQ2403 Management Software User's Guide 215
tx-
packets
--------------------------------------------------------------------------------------------------------------------
wlan1 00:0e:35:48:a7:ea Yes Yes 98 1
wlan1 00:11:95:df:83:b1 Yes Yes 320 27
AT-TQ2403# get association detail
Property Value
----------------------------------
interface wlan1
station 00:0e:35:48:a7:ea
authenticated Yes
associated Yes
rx-packets 98
tx-packets 1
rx-bytes 15880
tx-bytes 78
tx-rate 540
listen-interval 10
last-rssi 44
Property Value
----------------------------------
interface wlan1
station 00:11:95:df:83:b1
authenticated Yes
associated Yes
rx-packets 322
tx-packets 29
rx-bytes 20910
tx-bytes 2336
tx-rate 540
listen-interval 10
last-rssi 41
Get Neighboring APs
The Neighboring AP view shows wireless networks within range of the access point. These commands
provide a detailed view of neighboring APs including identifying information (SSIDs and MAC addresses)
for each, and statistical information such as the channel each AP is broadcasting on, signal strength, and
so forth.
To see the kinds of information about AP neighbors you can search on, type get detected-ap TAB
TAB.
AT-TQ2403# get detected-ap
[Enter] * Get common properties *
band Frequency band
beacon-interval Beacon interval in kus (1.024 ms)
beacons Number of beacons received
capability IEEE 802.11 capability value
channel Channel
detail * Get all properties *
erp ERP
last-beacon Time of last beacon
mac MAC address
phy-type PHY mode detected with
privacy WEP or WPA enabled
radio Radio detected with
rate Rate
signal Signal strength