user manual

216 AT-TQ2403 - Management Software - User's Guide
ssid Service Set IDentifier (a.k.a., Network Name)
supported-rates Supported rates list
type Type (AP, Ad hoc, or Other)
wpa WPA security enabled
To get the neighboring access points, type get detected-ap.
AT-TQ2403# get detected-ap
mac type privacy ssid channel signal
-----------------------------------------------------------------------------------------------------------
00:0a:79:5b:fe:43 AP On ATTW-OFFICE 6 3
00:0a:79:94:ae:93 AP Off LANKom Electronics Co., Ltd. 6 7
00:01:02:03:03:10 AP Off allied 6 4
00:0a:79:98:0d:f7 AP Off GO 6 14
00:01:02:03:aa:10 AP Off developing 6 20
00:01:02:03:03:00 AP Off allied 36 12
Ethernet (Wired) Interface

Note: Before configuring this feature, make sure you are
familiar with the names of the
interfaces as described in “Understanding Interfaces as Presented in the CLI
”. The interface
name you reference in a command determines whether a setting applies to a wired or
wireless interface, the Internal or Guest network, or (on a dual-radio AP) to radio "one" or
radio "two".
This table shows a quick view of commands for getting and setting values for the Wired interface and
links to detailed examples.
Feature or Setting CLI Command
Get the DNS Name get host id
Set the DNS Name set host id HostName
For example:
set host id vicky-ap
Get Wired Internal Interface
Settings
See “Get Current Settings for the Ethernet (Wired) Management
Interface” under Status.
Get Wired Internal Guest
Settings
“Get Current Settings for the Ethernet (Wired) Guest Interface” under
Status.
Secure Management Enable:
set management management-ip-enabled 1
Specify client to manage access
point
set management management-ip-addres MGMT_IP_Addr
For example:
set management management-ip-address 192.168.1.1