Instruction Manual

Doc. #: 0260011-J0 Rev B

;829; ;228.DIG INP2 FAILURE; ;0; ; ;

x Type of alarms for Digital inlet 2 (Inlet to be conﬁgured by user)

;830; ;229.REDUNDANCY LOST; ;1; ; ;

x Activates when redundancy is lost

;831; ;230.REDUND + 1 LOST; ;2; ; ;

x Activates when more than # of modules of redundancy are lost

;832; ;231.SYS SATURATED; ;1; ; ;

x Type of alarms when the threshold of pre-alarm “overload” is exceeded

;833; ;232.MAIN SOURCE LOST; ;2; ; ;

x Type of alarm when Main source is lost

x In AIM2500 mode : Main source is ACin = Network

x In ON LINE mode : Main source is DCin = battery

;834; ;233.SEC SOURCE LOST; ;1; ; ;

x Activates when Secondary source is lost

x In AC/AC mode : Secondary Source is DCin = battery

x In ON LINE mode : Secondary Source is ACin = Network

;835; ;234.T2S BUS FAIL; ;2; ; ;

x Activates when the T2S is lost

;836; ;235.T2S FAILURE; ;2; ; ;

x Activates when the T2S is not running

;843; ;242.LOG NEARLY FULL; ;0; ; ;

x Activates when the logﬁle is nearly full