Instruction Manual

Doc. #: 0260011-J0 Rev B
18
2.6 Network Requirements
The CXCU has a single Ethernet port on its front panel for communication with either the graphic
display or a laptop.
Figure 8 — Cable connection to CXCU for graphic display
CXCU RJ45
connection
Cable that connects
the CXCU to the
graphic display
2.6.1 Single Connection
The graphic display, which
uses a browser to launch CXC
web pages, is installed in
the DC distribution shelf (see
Figure 1). This display connects
to the Ethernet port on the front
of the CXCU.
To use a laptop to configure the
system, disconnect the graphic
display cable from the RJ45
jack on the CXCU (Figure 8).
Connect the laptop to the RJ45
jack with an Ethernet crossover
cable.
10. 10. 10. 202
255. 255. 255. 0
http://10.10.10.201/
Obtain an IP Address Using DHCP
Use the following IP Address
Default Gateway:
Subnet Mask:
IP Address:
Cancel Apply
Application SettingsCXC Connection SettingsIP Protocol SettingsConnection Status
Graphic Display
PC running IE8.0
or Firefox
CXCU installed
in AMPS24 HP shelf
OR
Ethernet
connector
Ethernet
connector
Figure 9 — Single network connection to CXCU