Instruction Manual

Doc. #: 0260011-J0 Rev B

2.6.2 Multiple Connections

Since the CXCU controller only has one port, a switch must be used for the following requirements:

• Simultaneous display at the graphic display and a local laptop

• Local display at the graphic display and remote Simple Network Management Protocol (SNMP) /

Ethernet functionality

Alpha Technologies has tested the Netgear JFS516 network switch, but network switches with the following

functionality will work:

• Network Interface: RJ-45 connector for 10BASE-T or 100BASE-TX Ethernet interface

• Meets IEEE 802.3i 10BASE-T Ethernet, IEEE 802.3u,100BASE-TX Fast Ethernet

• Meets IEEE 802.3x Flow Control; compatible with Windows®

Figure 10 — Multiple network connections to the CXCU

PC running IE8.0

or Firefox

10. 10. 10. 202

255. 255. 255. 0

http://10.10.10.201/

Obtain an IP Address Using DHCP

Use the following IP Address

Default Gateway:

Subnet Mask:

IP Address:

Cancel Apply

Application SettingsCXC Connection SettingsIP Protocol SettingsConnection Status

Graphic Display

IE7.0 or greater

or Firefox

Router or switch

Ethernet

connector

CXCU

Ethernet

PC running

Remote Network

Access