Instructions
EN - 4
This is a diagnostic charger. The Charger
DESCRIPTION LED STATUS
Red Red
Red Green
(remove for approx. 30
min. to allow to cool)
Red Orange
Red OFF
(remove and replace
Red Red
False Defect Note:
reinsert. If the status LED indicates
charger. Wait 1 minute and plug the charger
to be replaced.
NOTE When the red indictor ickers, pull out
the battery from the charger and insert again
within 2 hours. If the indictor shows charging,
that means the battery is good. After 2 hours,
please pull out the battery and also pull out the
AC power plug of the charger for 1 miniute, and
then insert the AC power plug and the
battery again. If the indictor shows charging,
that means the battery is good. If not,
the battery needs to be changed.
CHECKING THE CHARGER
•
•
• If the surrounding air temperature is not
normal room temperature, move the charger
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the
charger from approximately 30 minutes.
CHARGER MOUNTING
• This charger can be installed hanging on
a wall using two screws (not supplied).
• Locate the placement for the
charger to be wall mounted.
• If fastening to wood studs use 2 wood screws.
• Drill two holes 2 3/8” (6 cm) on
•
screws to secure the charger to the wall.
NOTE If the battery and the charger won’t be
used for a long time, please remove the battery
from the charger and pull out the AC power plug.
IMPORTANT SAFETY INSTRUCTIONS
• SAVE THESE INSTRUCTIONS -
DANGER: TO REDUCE RISK OF FIRE
OR ELECTRIC SHOCK CAREFULLY
FOLLOW THESE INSTRUCTIONS.
•
6. CLEANING
To avoid risk of re, electric
shock, or electrocution:
• Do not use a damp cloth or detergent
•
cleaning, inspecting, or performing