Owner's Manual

19-EN
Connecting to an External Amplifier (POWER IC)
When an external amplifier is connected, sound quality can be
improved by stopping the power supply of the built-in amplifier.
 Setting item: POWER IC
Setting contents:
ON (Initial setting) / OFF
ON:
The speakers are driven by the built-in amplifier.
OFF:
Use this mode when the line output of this unit is used to drive an
external amplifier. In this setting, the head unit’s internal amplifier
is turned OFF and cannot drive speakers.
ON:
OFF:
Note
• No sound is produced by the system when the power output is set to
OFF.
MX (Media Xpander) makes vocals or instruments sound distinct
regardless of the music source. The CD and iPod, etc. will be able to
reproduce the music clearly even in cars with a lot of road noise.
 Setting item: MX SETTING
1 Turn the Rotary encoder to select the source to which you
want to apply Media Xpander, and then press ENTER.
FM
*1
 ANALOG TU
*2
 HD1
*2
 HD2
*2
 HD3&OTHER
*2

SIRIUSXM
*2
 CD  CMPM
*3
 USB  IPOD  BT AUDIO 
PAND OR A  AUX  FM
*1 Only for CDE-147BT.
*2 Only for CDE-HD148BT.
*3 Be applied for MP3/WMA/AAC files in disc.
2 Turn the Rotary encoder to select the Media Xpander
level, and then press ENTER.
OFF  LEVEL 1  LEVEL 2  LEVEL 3  CUSTOMIZE  OFF
Customizing the Media Xpander setting
If CUSTOMIZE is selected in step 2, you can modify the Media Xpander
to suit your personal preference.
3 Turn the Rotary encoder to select the Band, and then
press ENTER. BAND1 (Lower frequencies)  BAND3
(Higher Frequencies)
BAND1 (Bass)  BAND2 (Mid)  BAND3 (High)  BAND1 (Bass)
4 Turn the Rotary encoder to adjust the level, and then
press ENTER.
LEVEL: 0 ~ 8
5 Repeat steps 3 to 4 to complete the setting of other bands.
You can change the unit of time correction (centimeters or inches).
 Setting item: LENGTH
Setting contents:
CM (Initial setting) / INCH
CM:
Time correction value is in centimeters.
INCH:
Time correction value is in inches.
Before performing the following, refer to “About Time Correction” on
page 21.
1 Turn the Rotary encoder to select the desired speaker
after selecting TCR, and then press ENTER.
FRONT-L  FRONT-R  REAR-L  REAR-R  SUBW-L  SUBW-R
 FRONT-L
2 Turn the Rotary encoder to adjust the distance of the
selected speaker, and then press ENTER.
0.0 cm to 336.6 cm (3.4 cm/step)
0.0 inch to 132.7 inch (1.3 inch/step)
External Device
Speakers
SPEAKER
RIGHT FRONT
Front
Right
SPEAKER
RIGHT REAR
Rear
Right
SPEAKER
LEFT REAR
Rear
Left
SPEAKER
LEFT FRONT
Front
Left
Front
Left
Amplier
Front
Right
Rear
Left
Amplier
Rear
Right
Setting the Media Xpander mode
Setting the Time Correction Unit
(LENGTH)
Adjusting the Time Correction (TCR)