Operation Manual

1. Identify the location of the vehicle power outlet and the auxiliary

audio input (if required).

2. Uncoil the cable (A) from the receiver (B) and place in its intended

position. Check there is adequate length for the cable to run to the

12V accessory socket and the auxiliary connection.

3. Route the cable so it is near your 12V accessory socket (C). Try to

secure the cable by tucking the cable behind the trim on the side of

your windscreen.

4. If you are connecting EZi-DAB-BT to your audio system using the

auxiliary connection, separate the auxiliary cable (D) from the USB

power cable by gently pulling the cables apart to the right length

and connect to the auxiliary connection (E) on your audio system.

If you are using FM transmission, coil the auxiliary connection cable

and stow away in a safe position.

Secure the cables using the self-adhesive clips (F) (if required).

Ensure

all surfaces are completely clean and dry before adhesion.

Installing the main cable

Cable routing overview

WARNING: Do not route the main cable in a way that could

interfere with operation of the vehicle, or through a location

that could interfere with the function of the airbags or other

safety equipment. See page 5 for more information.

1 2 3 4

5 6 7 8

1. Connect the microphone to your receiver and run the cable (G) along the top of your windscreen near the driver’s position.

2. Fit the microphone (H) near the driver’s position using the supplied pads or microphone clip.

Note: For best results, position the microphone as close as possible to the driver’s position.

3. Secure the microphone cable using the self-adhesive clip.

Installing the microphone