Operation Manual

25
EN
Appendix
Troubleshooting
I can’t reset EZi-DAB-BT to factory settings from my wireless controller
If you can’t access the ‘RESET’ menu on your wireless controller, you can reset EZi-DAB-BT using the Reset button on EZi-DAB-BT’s receiver.
Note: You will need to use a paperclip or pen to reset EZi-DAB-BT to factory settings.
To reset EZi-DAB-BT to factory settings:
1. Remove and re-insert the EZi-DAB-BT power adapter into the 12V accessory socket.
2. Within 5 seconds, while the Status LED on EZi-DAB-BT’s receiver is lit solidly, use a paperclip or pen to press the Reset button.
The Status LED will flash rapidly three times to indicate that the factory reset has started.
My wireless controller displays a ‘Antenna connecting’ message
Check the power supply to the receiver is properly inserted into your vehicle’s power socket.
Check that EZi-DAB-BT is not in USB upgrade mode.
Power cycle your receiver by removing and re-inserting the USB EZi-DAB-BT power adapter.
The Status LED on EZi-DAB-BT’s receiver is constantly illuminated
If the Status LED on EZi-DAB-BT’s receiver is constantly illuminated, it means that EZi-DAB-BT is expecting a software update via the
USB connection. If this is unintentional, you can exit USB update mode by removing the power or by holding down the Reset button
for 10 seconds.