Operation Manual

26
The Status LED on the receiver is flashing rapidly
If the Status LED is flashing rapidly on the receiver it means that the wireless controller has lost its connection with the receiver. To
resolve this, you will need to manually re-pair the receiver and controller.
1. Remove and re-insert the EZi-DAB-BT power adapter into the 12V accessory socket and wait 5 seconds until the
Status LED on the receiver goes out.
2. Use a paperclip or pen to press the Reset button on the receiver. The Status LED on the receiver will start to blink slowly.
3. Press and hold the , and buttons simultaneously on the wireless controller for 10 seconds. All the segments on
the wireless controller will briefly light up and ‘ANTENNA CONNECTING’ will be shown on the display.
The Bluetooth icon on the controller will blink while the receiver and wireless controller try to connect.
If the receiver and controller still fail to connect, then you will need to reset your receiver back to factory settings (see the reset
instructions on the previous page), and repeat step 3.
The wireless controller is not responding
1. Check that the batteries in the wireless controller have not gone flat. If they have, the screen will not light up when you
press the button.
2. Check that the receiver is powered. To test this, remove then re-apply power to the receiver. The status LED should light
for 5 seconds to confirm power supply.
3. If the batteries and power are OK, check that the wireless controller and receiver are properly paired. Press and hold the
, and buttons simultaneously on the wireless controller. If paired correctly, the Status LED on the receiver should
light solidly, and turn o as soon as you release the buttons. If the Status LED does not light up when you press and hold
the
, and buttons, you will need to re-pair the controller and receiver. For re-pairing instructions see ‘The Status
LED on the receiver is flashing rapidly’ above.
The audio on EZi-DAB-BT sounds distorted when I connect EZi-DAB-BT to my existing audio system using the auxiliary connection
If the audio on EZi-DAB-BT sounds distorted when you’ve connected EZi-DAB-BT to your audio system via the auxiliary connection,
try setting the ‘GAIN’ value to ‘LOW’. If this still doesn’t solve the problem, try using ‘FM TRANSMIT’ instead (see page 22 for more
information).
EZi-DAB-BT turned itself o
See ‘Auto standby’ on page 22.