Operation Manual

5
EN
Installing EZi-DAB-BT in your vehicle
Important safety notice
For your safety, do not run cables so that they interfere with operation of the vehicle, or through a location that would interfere
with the function of the airbags or other safety equipment, for example seat belts. Do not install any of EZi-DAB-BT’s components
in a location that obstructs the view of the driver or in a location where digital radio interference may be caused from the metal
bodywork or other components.
Receiver positioning overview
The receiver is designed to be installed on a window
using the self-adhesive pads provided.
Make sure that you install the receiver in a safe position
where the primary viewing area is not obstructed. Your
windscreen can be divided into separate zones to help
you determine where the receiver can be safely placed:
Zone A is a vertical area 290mm wide, centred on the
steering wheel and contained within the swept area of
the windscreen (this area is 350mm wide on vehicles
over 3.5 tonnes) which must not be incurred upon by
more than 1cm.
Note: Fitting EZi-DAB-BT in this area is not recommended.
Zone B is the remainder of the swept area of the
windscreen which must not be incurred upon by more
than 4cm.
The above information is a guide only, for full
information you should consult the relevant country
department of transport guidelines.
Max 1cm
incursion
Max 4cm
incursion
No restriction
Zone B Zone A
Suggested position