Owner's Manual

If an ACC power supply is not available
Connection Diagram of SPST Switch (sold separately)
ACC
(Red)
BATTERY
1----------------,
------7..._~•,_ __ s_P_S_T_s_w,...,(0
0
:t_io_n_a_l~--:~F-U~SCE~(~S,A)
, (Optional)
0
H
----------------------------c:::>-~
(Yellow)
FUSE (20A)
(Optional)
e Etl
Battery
• If your vehicle has no ACC power supply, add an SPST (single- pole , single-throw) switch (sold separately) and fuse (sold
separately).
• The diagram and the fuse amperage shown above are in the case when the unit is used individually.
• If the switched power (ignition) lead of the unit is connected directly to the positive(+) post of the vehicle's battery, the
unit draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the
battery may be discharged.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare _ metal spot (remove any paint, dirt or grease if necessary) of the car
chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible . Your Alpine dealer
ca"ies various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
8 -EN