Owner`s manual

31-EN
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if
applicable.
Note
This lead should be used only for controlling the vehicle’s power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or
signal processor.
Illumination Lead (Orange)
This lead may be connected to the vehicle’s instrument cluster
illumination lead. This will enable the vehicles dimmer control to dim
the backlighting of the unit.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicles fuse box or
another unused power source which provides (+) 12V only when the
ignition is turned on or in the accessory position.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure
the connection is made to bare metal and is securely fastened using
the sheet metal screw provided.
Right Front (+) Speaker Output Lead (Gray)
Right Front (−) Speaker Output Lead (Gray/Black)
Right Rear (−) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (−) Speaker Output Lead (Green/Black)
Left Front (−) Speaker Output Lead (White/Black)
Left Front (+) Speaker Output Lead (White)
Antenna Receptacle
Front Output RCA Connectors (CDE-152 only)
RED is right and WHITE is left.
Rear Output RCA Connectors (CDE-152 only)
RED is right and WHITE is left.
Front Output RCA Connectors (CDE-151/CDE-150 only)
RED is right and WHITE is left.
Subwoofer Output RCA Connectors (CDE-152 only)
Rear/Subwoofer Output RCA Connectors (CDE-151/CDE-150
only)
RED is right and WHITE is left.
Fuse Holder (10A)
Power Supply Connector
RCA Extension Cable (sold separately)
USB Terminal
Connect this to a Flash Memory or an iPod/iPhone (sold separately).
Front AUX Input Terminal
This terminal allows for input of audio from an external device (such
as a portable player), using a commercially-available converter cable.