Specifications

PH/LINE
LINE
GAIN
CLIP
3
X-FADE
A
B
CUE
HF
MID
BASS
INPUT CHANNELS 3 to 6
Input Sources. These channels have a stereo RIAA phono stage and
a normal stereo line input both on twin gold plated RCA phono
connectors. The phono stage may be configured as a second line
input by depressing a concealed push switch available through a hole
in the rear panel.
Input selector switch selects the input used.
Button depressed selects Phono/line (depending on configuration).
Button not depressed selects Stereo line input.
Blue and red l.e.d.s. and labels clearly show which input is in use.
Channel meter this is a 5 segment l.e.d. meter and it displays the pre-
fader signal level within the channel. The normal reading for this
meter is amber with occasional peaks into the red.
Gain control. This sets the input gain level, and should be used in
conjunction with the rear panel gain trims. A gain trimmer is provided
for every input so that all input sources can be matched to the same
level. The control is then used to compensate for differences in track
levels.
Clip indicator. This is a red l.e.d that indicates when the channel signal
is just below clipping. If lit it means that the gain is set too high.
3 Band equalisation provides +5dB boost and -23dB cut @
HF 10kHz MID 1kHz BASS 100Hz.
The centre detent denotes the flat position.
X-Fade A and B. Rectangular push button switches with red and
green illumination. Depressing the switches routes the channel via the
VCA controlled crossfader and associated effects loops if selected.
The channel signal may be routed to either end of the
X-fader.
The red and green colour coding are maintained through out the
X-fader and associated effects loops to give clear visual indication of
routing status.
If neither button is depressed the signal is routed directly to the
output section.
Cue. A larger round illuminated push button is provided for cue
selection. When depressed the channel signal is fed to the cue buss.
Any number of sources may be selected simultaneously, the sum of
which will be available to the headphones monitoring section.
Fader. A 60mm channel fader (or rotary fader depending on what
fader option has been fitted ) is available to mix the various
channels as required.
4