Quick Setup Guide

Quick Setup Guide

3. Configure security for WLAN connection. Click the hyperlink of Auth Mode,

which is “open” in the above screenshot and you will be directed to the

WLAN Security page. In this example, the WLAN that the VX200 connects

to is WPA2-Personal protected, so passphrase is required. If you are not

sure about the authentication mode that the WLAN is using, contact your

network administrator. Once the setting is done, click Submit button.

4. Click Save & Apply at the top right corner to have all changes take effect.

5. To view connection status, go toStatus > Radio0(2.4G)/Radio1(5G)>

Connection Info. If the connection is successful, it should show

“Connected” under the AP Info table.