V-MATRIX® MANUAL PART NUMBER: 400-0387-003 VM2382CF V-MATRIX, 8-OUT, SINGLE CHANNEL TWISTED PAIR OUTPUT CARD USER'S GUIDE
V-MATRIX TABLE OF CONTENTS Page PRECAUTIONS / SAFETY WARNINGS................ 2 GENERAL..........................................................2 HANDLING ........................................................2 CLEANING.........................................................2 FCC NOTICE .....................................................2 ABOUT YOUR VM2382CF....................................... 3 TECHNICAL SPECIFICATIONS.............................. 3 PRODUCT DESCRIPTION ...........................
V-MATRIX PRECAUTIONS / SAFETY WARNINGS 1.5 FCC NOTICE 1 • Please read this manual carefully before using your VM2382CF and keep it handy for future reference. These safety instructions are to ensure the long life of your VM2382CF and to prevent fire and shock hazards. Please read them carefully and heed all warnings. 1.1 GENERAL • • Qualified ALTINEX service personnel or its authorized representatives must perform all service. 1.2 HANDLING • Handle the VM2382CF carefully.
V-MATRIX ABOUT YOUR VM2382CF 2 TECHNICAL SPECIFICATIONS 3 VM2382CF Specifications are subject to change. 8-OUT, 1TP Output Card for V-Matrix See www.altinex.com for up-to-date information. The VM2382CF is an 8 Twisted Pair Output card designed for use with all ALTINEX standards for Twisted Pair signal transmission including TP receivers like the DA1931CT and MT103-123.
V-MATRIX PRODUCT DESCRIPTION 4 TOP RETAINER SCREW 8 TWISTED PAIR OUTPUTS (1 TP PER OUTPUT) BOTTOM RETAINER SCREW 400-0387-003 4
V-MATRIX APPLICATION DIAGRAMS 5 DIAGRAM 1: TYPICAL SETUP VM2382CF MS8704TP DA1931CT MS8704TP DA1931CT 400-0387-003 5
V-MATRIX DIAGRAM 2: INTERNAL VIEW VM2382CF, 8 TP OUTPUTS, SINGLE CHANNEL V-MATRIX CARD EDGE CONNECTOR 400-0387-003 IN1 OUT1 IN2 OUT2 IN3 OUT3 IN4 OUT4 IN5 OUT5 IN6 OUT6 IN7 OUT7 IN8 OUT8 6 1TP (X8) RJ-45
V-MATRIX INSTALLING YOUR VM2382CF 6 TROUBLESHOOTING GUIDE Step 1. Turn off power to the V-Matrix enclosure. 8 The VM2382CF unit supplied was carefully tested and no problems were found. However, we would like to offer the following suggestions: Step 2. Remove a slot cover (VM2005BP) from one of the unused slots of the enclosure in order to install the VM2382CF. 8.1 NO DISPLAY Step 3. Slide the VM2382CF into the slot in the enclosure in order to connect it to the bus.
V-MATRIX Cause 3: The card has a problem. ALTINEX POLICIES Solution 1: Look at the card and verify that there is no damage. If there is no damage, see Solution 2. 9.1 LIMITED WARRANTY/RETURN POLICIES Please see the ALTINEX website at www.altinex.com for details on warranty and return policies. Solution 2: Make sure the display is powered and turned on. If there is still no display, see Cause 4. Cause 4: There is an unknown problem.