Instructions / Assembly

Visit www.altitudefans.com/install for installation video tutorials and product support
10
NOTE:
If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING:
To avoid possible re or shock, be sure
electricity is turned off at the main fuse box
before hanging. (Figure 1)
WARNING:
The fan must be hung with at least 10’ of
clearance from floor to ceiling fan. (Figure 2)
WARNING:
The outlet box must be securely anchored.
Hanger bracket must seat rmly against
outlet box. If the outlet box is recessed,
remove wall board until bracket contacts
box. If bracket and /or outlet box are not
securely attached, the fan could wobble or
fall.
WARNING:
Failure to seat tab in groove could cause
damage to electrical wires and possible
shock or re hazard.
WARNING:
To avoid possible shock, do not pinch wires
between the hanger ball assembly and the
hanger bracket.
☐
Securely attach the hanger bracket to the outlet box
using the outlet box screws and washers supplied with
the outlet box. (Figure 3)
☐
Carefully lift the fan and seat the downrod/hanger ball
assembly onto the hanger bracket that was just
attached to the outlet box. Be sure the groove in the ball
is lined up with tab on the hanger bracket. (Figure 4)
This fan is intended for standard and angled mounting
options only. Closemount and flushmount options are
not available. For angled ceilings, note the angle can
be no more than 20°.
HOW TO HANG YOUR CEILING FAN
Figure 3
Outlet Box
Hanger
Bracket
Screw (2)
Supplied with
Outlet Box
T
ab
Flat Washer(2)