Instructions / Assembly
Visit www.altitudefans.com/install for installation video tutorials and product support
☐
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for
reinstallation in Step 6. (Figure 1)
☐
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
☐
Loosen the two set screws in the downrod support of
the motor assembly. Route the black, white and blue
wires through the downrod. (Figure 3)
☐
Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with in the downrod support. (Figure 4)
☐
Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
8
WARNING:
It is critical that the clevis pin in the downrod
support is properly installed and the set
screws are securely tightened.
Figure 3
Figure 4
Figure 5