Owner's manual

Altman Lighting, Inc. 57 Alexander Street., Yonkers, NY 10701 1-800-4-ALTMAN
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC/ ALL RIGHTS RESERVED
1/24/14 rev:C
6
CLEANING / REPLACING LENSES
WARNING: Never use glass or window cleaner or any abrasive material to clean
a lens. These types of cleaners will stain the lens surface. Abrasive materials will
damage the surface of the lens.
1. Remove focus lock knob, push in safety
pin and slide lens barrel out.
2. Place barrel on a surface so that the two
halves are oriented as the top and bottom.
3. Remove lower accessory cover with (2)
screws.
4. Remove latch cover with (2) screws.
5. Remove (4) barrel screws, one on each
side.
6. Carefully remove top half of the barrel.
7. Replace or clean lenses with mild soap
and water, and a clean, lint-fee cloth.
8. Replace top half of barrel, top latch cover,
bottom cover and re-install screws.
9. Slide lens barrel back into unit and replace
focus lock knobs.
Top Latch Cover
Lens Retaining Rings
Lower Accessory Cover
Lens
Barrel Screws
Barrel Screws
36° (6 x 9)
26° (6 x 12) 19° (6 x 16)
50° (4.5 X 6)