Installation Guide

M series - 5 -
Wire
Strap
(from
Enclosure
to Door)
115VAC
power mains
non power-
limited
Class 1
Divider
NC C NO
DRY OUTPUT
TRIGGER
LED
6 78910
POS (+) DC OUTPUT (STANDBY)
NC C NO
POWER FAIL
TRIGGER
1 2345
POS (+) DC OUTPUT (ALARM)
NEG1 NEG2 NEG3 NEG4 NEG5
-- DC INPUT +
NEG (-) INPUT POS (+)
DC Outputs to devices
(power-limited)
Fire Alarm
Interface
Power-limited
Battery Connections
non power-limited
non power-limited
CAUTION: De-energize unit prior to servicing. For continued protection
against risk of electric shock and fire hazard replace fuses with the same type
and rating (see marking on the board). Do not expose to rain or moisture.
+ DC ---
NC C NO NC C NO
+ BAT ---
AC DC Bat
Risk of Fire, Replace Fuses As Marked
AC Fail
Bat Fail
J1
SW1
5A 250V
15A 250V
AC Delay
15
L G N
Battery and
AC Supervision Circuit
(power-limited)
NC C NO NC C NO
J1
AC Delay
SW1
Earth
Ground
Keep power-limited wiring separate from non power-limited.
Use minimum 0.25" spacing.
CAUTION: Optional rechargeable stand-by batteries must match
the power supply output voltage setting.
Optional Rechargeable
Stand-by Battery
Optional Rechargeable
Stand-by Battery
ON
1
OFF - 24V ON - 12V
ON
OFF - 24V
ON - 12V
Fig. 1 - AL300ULM, AL400ULM
Fig. 1a
Fig. 1b
Fig. 1c