Data Sheet
Input:
• 120VAC, 60Hz, 3.5 amp.
• Input fuse: 5A/250V.
Output:
• Sixteen (16) PTC protected power-limited outputs.
• 12VDC or 24VDC @ 6.0 amp supply current.
• Outputs are rated at 2 amp.
• Auxiliary power-limited output
rated @ 1 amp (unswitched).
• Overvoltage protection.
Battery Backup:
• Built-in charger for sealed lead acid or gel type batteries.
• Maximum charge current 1.54 amp.
• Automatic switch over to stand-by battery when
AC fails. Transfer to stand-by battery power is
instantaneous with no interruption.
Supervision:
• AC fail supervision (form “C” contacts).
- Notification trigger is selectable for
30 seconds (factory set) or 2 hours.
• Battery fail and presence supervision
(form “C” contacts).
• Low power shutdown. Shuts down DC output terminals
if battery voltage drops below 71-73% for 12V units
and 70-75% for 24V units (depending on the power
supply). Prevents deep battery discharge.
Fire Alarm Disconnect:
• Supervised Fire Alarm disconnect (latching or
non-latching) 10K EOL resistor. Operates on a
normally open (NO) or normally closed (NC) trigger.
Electrical:
• Operating temperature: 0º C to 49º C ambient.
• BTU/Hr.:
12VDC: 36.85 BTU/Hr.
24VDC: 73.71 BTU/Hr.
• System AC input VA requirement: 420VA.
Visual Indicators:
• Green AC Power LED indicates 120VAC present.
• AC input, DC output, and Battery LED indicators.
Additional Features:
• Short circuit and overload protection.
• Unit is complete with power supply, enclosure,
battery leads and cam lock.
Mechanical:
• Enclosure Dimensions (H x W x D approx.):
13.5” x 13” x 3.25” (342.9mm x 330.2mm x 82.55mm)
- Accommodates up to two (2) 12VDC/7AH batteries.
• Product weight (approx.): 6.8 lbs. (3.08 kg).
• Shipping weight (approx.): 7.7 lbs. (3.49 kg).
Specifications
eFlow6N16D is a power supply/charger that converts a 120VAC 60Hz input
into sixteen (16) PTC protected selectable 12VDC or 24VDC power-limited
outputs with a total of 6 amps max. The unit includes an unswitched aux. output.
It also offers a suite of features that includes fire alarm disconnect, overvoltage
protection, and low power disconnect which prevents deep discharge of stand-
by batteries.
eFlow6N16D
Power Supply/Charger
Rev. DSeFlow6N16D_05142015
Overview
eFlow6N16D
Agency Approvals
UL 294 UL Listed for Access Control
System Units.
UL 603 UL Listed for Power Supplies
for Use with Burglar-Alarms
Systems.
UL 1481 UL Listed for Power Supplies
for Fire Protective Signaling
Systems.
ULC-S318-96 - Power Supplies for
Burglar Alarm Systems. Also suitable for
Access Control.
CE - European Conformity
CSFM California State Fire
Marshal Approved.
Altronix Corp.
140 58th St. Brooklyn, NY