Instruction Manual

HubWayLD8CD Active UTP Transceiver Hub w/Integral Camera Power
transmits UTP video, RS422/RS485 data and power over a single CAT-5 or
higher structured cable. Unit provides 8 camera channels in a space saving 1U
EIA 19” rack mount chassis which may be rack, wall or shelf mounted. Video
transmission range is up to 3000 ft. max. per channel. Units are compatible
with AC and/or DC fixed or PTZ cameras when utilizing Altronix HubWayAv,
HubWayDv or HubWayDvi Video Balun/Combiners. In addition, the unit
features individually selectable 24VAC or 28VAC PTC protected outputs with
surge suppression. An optional HubSat4D Passive UTP Transceiver Hub with
Integral Camera Power can be used as an accessory module to transmit video
from up to 4 cameras over a single CAT-5 or higher structured cable back to
the HubWayLD8CD. In addition, the HubSat4D provides power to these cam-
eras locally to eliminate the possibility of voltage drop associated with long
cable runs.
Input:
• 115VAC50/60Hz,1.5amp.
•Primaryfuse(internal)isratedat5amp/250V.
Video:
• Eight(8)channelsofvideoovertwistedpair
 uptoadistanceof3000ft.(914.4m)perchannel.
• Eight(8)75ohmvideooutputs.
Data:
• RS422/RS485 data inputs.
Power:
• Individuallyselectable24VACor28VACpower
outputs with OFF position.
• Unitprovidesupto1ampmax.perchannelnotto
exceedatotalof5amp(150VA)maximumcurrent.
• Class2Ratedpowerlimitedoutputs.
• PTCprotectedoutputsarerated@1amp
per channel.
• Surgesuppression.
Visual Indicators:
•ACinputpowerindicator.
•VideosignalandpowerLEDindicators.
Features:
• Picture and Gain control.
• Illuminatedmasterpowerdisconnectcircuitbreaker
with manual reset.
• IEC 320 - 3-wiregroundedlinecord(detachable).
• Unitcanberack,wallorshelfmounted.
• 1UEIA19”rackmountchassis.
Accessories:
• OptionalHubSat4Dallowstransmissionofupto
 four(4)videosignalsoverasingleCAT-5orhigher
structured cable.
• VideoBalun/Combiners:
- HubWayAv2 - for use with 24VAC cameras.
- HubWayDv - for use with 12VDC cameras.
- HubWayDvi - for use with 12VDC
cameras without isolation.
Mechanical:
• Modular1UstandardEIA19”rackmountchassis
• EnclosureDimensions(HxWxDapprox.):
 1.625”(41.275mm)x19.125”(486mm)
x 2.498”(63.45mm)
- HubWayLD8CD:13.5lbs.(6.12kg)
- HubWayLD82CD:14.7lbs.(6.67kg)
- HubWayLD83CD:14.2lbs.(6.44kg)
HubWay
®
LD8CD Active UTP Transceiver Hub
with Integral Camera Power
Rev.DSHubWayLD8CD_10262012
Overview
Specifications
Agency Approvals
UL Listed for Commercial CCTV Equipment
(UL2044).
CUL Listed - CSA Standard C22.2 No.1-04,
Audio, Video and Similar Equipment.
HubWayLD8CD