Installation

- 4 - HubWay Passive Unit
AC POWER
8 7 6 5 4 3 2 1
24VAC
OFF
28VAC
-- DATA +
1234
5678
CH 1-4
CH 5-8
1-8
1g - Channels 1-8: CAT-5 or higher structured cable to Video/Balun Combiners at cameras 1-8. When linking HubWay UTP Transceiver Hubs to HubSat Remote Accessory Modules, any of these jacks will facilitate data transmission for PTZ control.
1d - BNC Connector: Video outputs to head end equipment (DVR).
1a - Output voltage switches: Selects 24VAC/28VAC/OFF for each output.
1f - Channels 1-4 & Channels 5-8: Links HubSat units enabling video transmis- sion of up to four (4) cameras over a single CAT-5 structured cable.
1e - IEC 320 Connector: 115VAC/230VAC 50/60Hz (grounded line cord included).
Fig. 1
1c - Data: Removable terminal blocks for RS422/ RS485 input from head end equipment (DVR) for PTZ control.
+ --
Data input from
Head End
Equipment (DVR).
Top View
1h - Input Voltage Switch: Selects 115VAC 60Hz/230VAC 50/60Hz (switch is located on the left side of the unit).
115VAC 220VAC
1b - LED(s) 1-8: Power indicators.
Rear