Installation Instructions Manual

ManualsBrandsAltronix ManualsAccessories for electricalOLS180

Overview:

The OLS180 is a power supply/charger that converts 115VAC / 60Hz input, into a 12VDC or 24VDC @ 6 amps

of continuous supply current (see specifications).

Specifications:

• 12VDC or 24VDC selectable output.

• 6 amp continuous supply current.

• Input 115VAC / 60Hz, 1.9 amp.

• Filtered and electronically regulated outputs.

• Built-in charger for sealed lead acid or gel type batteries.

• Maximum charge current .5 amp.

• Automatic switch over to stand-by battery when AC fails (zero voltage drop).

• AC input and DC output LED indicators.

• AC fail supervision (form "C" contacts).

• Low battery supervision (form "C" contacts).

• Short circuit and thermal overload protection.

• Power ON/OFF switch.

• Includes battery leads.

Board Dimensions: 4.5”W x 7.25”L x 1.75”H

Specified at 25˚ C ambient.

Voltage Output Selection Table:

Output VDC Switch Position Max. Load DC

12VDC

SW 1 - Closed 6 amp

24VDC SW1 - Open 6 amp

Installation Instructions:

The OLS180 should be installed in accordance with The National Electrical Code and all applicable Local Regulations.

1. Mount the

OLS180 in desired location/enclosure.

2. Slide [Power ON/OFF] switch to OFF position.

Set the OLS180 to desired DC output voltage via SW1

oltage Output Selection Table

4. Connect AC power to terminals marked [L & N], connect ground to terminal marked [G].

Use 18

WG or larger for all power connections (Battery, DC output).

Use 22 AWG to 18 AWG for power limited circuits (AC Fail/Low Battery reporting).

Measure output voltage before connecting devices. This helps avoid potential damage.

6. Connect devices to be powered to terminals marked [– DC + ].

7. When the use of stand-by batteries are desired, they must be lead acid or gel type.

Connect batter

y to ter

minals mark

ed [– B

T +] (battery leads included).

Use two (2) 12VDC batteries connected in series for 24VDC operation.

Note: When batteries are not used a loss of AC will result in the loss of output voltage.

8. Connect appropriate signaling notification devices to AC Fail & Low battery supervisory

rela

y outputs mark

ed [NC, C, NO].

9. Slide [Power ON/OFF] switch to ON position.

OLS180 - Offline Switching

Power Supply/Charger

Summary of content (2 pages)

PAGE 1
OLS180 - Offline Switching Power Supply/Charger Overview: The OLS180 is a power supply/charger that converts 115VAC / 60Hz input, into a 12VDC or 24VDC @ 6 amps of continuous supply current (see specifications). Specifications: • 12VDC or 24VDC selectable output. • 6 amp continuous supply current. • Input 115VAC / 60Hz, 1.9 amp. • Filtered and electronically regulated outputs. • Built-in charger for sealed lead acid or gel type batteries. • Maximum charge current .5 amp.
PAGE 2
LED Diagnostics: Red (DC) ON ON OFF OFF Green (AC) ON OFF ON OFF Power Supply Status Normal operating condition. Loss of AC, Stand-by battery supplying power. No DC output. Short circuit or thermal overload condition. Loss of AC. Discharged or no stand-by battery. No DC output. Terminal Identification: Terminal Legend Function/Description L, G, N Connect 115VAC to these terminals: L to Hot, N to Neutral, G to ground. – DC + 12VDC / 24VDC @ 6 amp continuous output.