Installation Instructions Owner's manual

Overview:
The OLS200 is a power supply/charger that converts 115VAC 50/60Hz input into a 12VDC @ 10 amp of continuous
supply current (see specifications).
Specifications:
Installation Instructions:
The OLS200 should be installed in accordance with The National Electrical Code and all applicable Local Regulations.
1. Mount the OLS200 in the desired location/enclosure.
2. Connect AC power to the terminals marked [L & N], connect ground to the terminal marked [G].
Use 18 AWG or larger for all power connections (Battery, DC output, AC input).
Use 22 AWG to 18 AWG for power limited circuits (AC Fail/Low Battery reporting).
Keep power-limited wiring separate from non power-limited wiring (DC output, 115VAC 50/60Hz Input,
Battery Wires). Minimum 0.25” spacing must be provided.
3. Measure output voltage before connecting devices. This helps avoiding potential damage.
4. Connect devices to be powered to the terminals marked [– DC + ].
5. When the use of stand-by batteries is desired, they must be lead acid or gel type.
6. Connect battery to the terminals marked [– BAT +] (battery leads included).
Note: When batteries are not used, a loss of AC will result in the loss of output voltage.
7. Connect appropriate signaling notification devices to AC Fail & Low battery supervisory
relay outputs marked [NC, C, NO].
LED Diagnostics:
Red (DC) Green (AC) Power Supply Status
ON ON Normal operating condition.
ON OFF Loss of AC, Stand-by battery supplying power.
OFF ON No DC output. Short circuit or thermal overload condition.
OFF OFF Loss of AC. Discharged or no stand-by battery. No DC output.
OLS200 - Off-line Switching Power Supply/Charger
Input:
• 115VAC,50/60Hz,1.9amp.
Output:
• 12VDC output.
•10ampcontinuoussupplycurrent.
• Filteredandelectronicallyregulatedoutput.
• Shortcircuitandthermaloverloadprotection.
Battery Backup:
• Built-inchargerforsealedleadacidor
gel type batteries.
• Automaticswitchovertostand-bybattery
when AC fails.
• Maximumchargecurrent0.7amp.
Supervision:
• ACfailsupervision(form“C”contacts).
• Lowbatterysupervision(form“C”contacts).
Visual Indicators:
• ACinputandDCoutputLEDindicators.
Features:
• PowerON/OFFswitch.
• Includesbatteryleads.
Board Dimensions (L x W x H approximate):
7.25”x4.5”x1.75”(184.1mmx114.3mmx44.45mm).