Spec Sheet

- 24VDC @ 10A power supply charger.
- Accommodates the following Paxton module Net2 Plus.
- Convenient knockout configuration:
- Single 2” diameter knockout located top center
of enclosure
- Sixteen (16) double knockouts (1” and 0.75”).
- 16 AWG galvanized steel backplane simplifies board layout
and wire management.
- Supervision
- AC Fail
- Low Battery and Battery Presence
- Low power shutdown.
- Eight (8) Fail-Safe/Fail-Secure outputs.
- CE European Conformity.
- Enclosure accommodates up to four (4)
12VDC/12AH batteries.
- Lifetime Warranty* / Made in the U.S.A.
Key Features
T2PXK7F8
Access & Power Integration Solution
Rev. T2PXK7F8 - 04012020
All registered trademarks are property of their respective owners.
T2PXK7F8
Description
Altronix T2PXK7F8 kit consists of Trove2 enclosure, TPX2 Paxton/
Altronix backplane with one (1) 24VDC @ 10A power supply/charger,
one (1) fuse protected eight (8) output access power controller and one
(1) fuse protected eight (8) dual output power distribution module and
one (1) voltage regulator. This kit also accommodates Paxton Net2 Plus
boards for up to eight (8) doors in a single enclosure. Trove simplifies
board layout and wire management, reduces installation time and labor
costs.
*Altronix Power Supply/Chargers and Sub-Assemblies only
Accessories (order separately)
LINQ2 - Network Supervision
Altronix LINQ2 Network Communication Module provides remote supervision, control and monitoring over LAN/WAN
- Remotely reports accurate power diagnostics
- Controls power and resets devices
- Reports system diagnostics via Email
WM5, WM25, WM100 - Magnetic Cable Tie Mounts
Altronix WM5, WM25, and WM100 are packs of 5, 25 or 100 magnetic cable tie mounts respectively.
They accommodate standard zip ties or velcro straps. These are ideal for wire management in our Trove series.
MM4, MM8, MM12, MM24 - Magnetic Mounting Solution
Altronix mounting magnets accommodate screws and nylon standoffs to allow for mounting various boards/
accessories in any metal enclosure or backplane.
WM5
LINQ2
Mounting Magnet
* Paxton boards not included