Installation Instructions Instruction Manual

ManualsBrandsAltronix ManualsAccessories for electricalWayPoint-30A

AC Outdoor Power Supply/Chargers

Installation Guide

Models Include:

WayPoint-10A

- 24VAC @ 4 amp and/or 28VAC @ 3.5 amp.

WayPoint-17A

- 24VAC @ 7.25 amp and/or 28VAC @ 6.25 amp.

WayPoint-30A

- 24VAC @ 12.5 amp or 28VAC @ 10 amp.

Rev. 080911ACPL More than just power.™

Summary of content (8 pages)

PAGE 1
AC Outdoor Power Supply/Chargers Installation Guide Models Include: WayPoint-10A - 24VAC @ 4 amp and/or 28VAC @ 3.5 amp. WayPoint-17A - 24VAC @ 7.25 amp and/or 28VAC @ 6.25 amp. WayPoint-30A - 24VAC @ 12.5 amp or 28VAC @ 10 amp. Rev. 080911ACPL More than just power.
PAGE 2
Overview: These Altronix Outdoor Power Supplies provide 24VAC or 28VAC distributed via one or two output(s) for powering CCTV Cameras, heaters and other video accessories. WayPoint-10A WayPoint-17A WayPoint-30A 24VAC 28VAC 24VAC and 28VAC 24VAC 28VAC 24VAC and 28VAC 24VAC 28VAC 24VAC and 28VAC 4 amp 3.5 amp 3.5 amp 7.25 amp 6.25 amp 6.25 amp 12.
PAGE 3
Fig.
PAGE 4
Fig.
PAGE 5
Fig.
PAGE 6
Fig. 4 Suggested Locations for Wiring Inlets Bottom of Enclosure Terminal and LED Identification Chart: Output Terminals LED COM & 24V 24VAC COM & 28V 28VAC LED Status ON OFF Normal operating condition. No AC output. Blown fuse, Illuminated master power disconnect circuit breaker is tripped or OFF, AC failure.
PAGE 7
Wall Mount Installation 1- Place unit at desired location and secure with mounting screws (not included) (Fig. 5 and Fig. 5a, pg. 7). Fig. 5 Fig.
PAGE 8
Enclosure Dimensions (H x W x D): 11.32” (287.528mm) 8.00” (203.2mm) STAINLESS STEEL PIANO HINGE 13.31” (338.074mm) x 11.31” (287.274mm) x 5.59” (141.986mm) Fig. 6 13.32” (338.328mm) 1.61” (40.894mm) 5.60” (142.24mm) 3.96” (100.584mm) PADLOCK LATCH ATTACHED WITH RIVETS (Ø 0.375” (9.52mm) PADLOCK EYE). Ø 0.32 (8.128mm) MOUNTING HOLE TYP. 4 PLACES 12.75” (323.85mm) 12.00” (304.8mm) 13.50” (342.9mm) 10.75” (273.05mm) 10.00” (254mm) 8.25” (209.55mm) 10-32 X 0.375” (9.525mm) BRASS INSERT (X4) 10.