User manual

Chapter 4. Administration

1. Select the desired attributes for the port, then click OK. You return to the

previous screen (Setting I/O Module Attributes). To exit without saving

your changes, click Cancel.

2. When you return to the previous screen, click Apply to keep your changes.

To exit without saving your changes, click Cancel.

Miscellaneous

The functions performed by the remaining elements at the bottom of the screen

are described in the table, below:

Parameter Explanation

Reset on Exit Placing a check here causes the KN2108 / KN2116 to reset itself

and implement all the new changes when you log out. Following the

reset, wait approximately 30 to 60 seconds before logging back in.

For example, if you change the IP address in the Network dialog

box, you must open this page and enable Reset on exit before

logging out. Otherwise, the change will not take effect

Reset Values Clicking this button undoes all changes that have been made to the

Configuration and Administration pages (except for the Port Names

that were assigned to the Ports - see Port Names, page 42) and

returns the parameters to the original factory default settings

(see OSD Factory Default Settings, page 152).

Clear Name List This function clears the Port Name settings.