User Manual

Page 7 of 8

EPH-N00-06086

6-3-02

Adjust the drip vinyl [N] by sliding it left or

right until it just touches the curb. Trim the vinyl

flush with the hinge side and notch 1/2" longer than

the drip rail [L] as shown on the strike side. Slide the

vinyl into the drip rail and secure it on the hinge side

of the drip rail with one #6 x 3/8" truss head screw [P].

The drip plug [R] is supplied with a left and right hand

plug together. Break the two pieces apart and insert

the appropriate plug into the high (strike) side of the

drip rail. Discard the unused drip plug. Peel off the

tape backing [M] and carefully press the drip rail to the

door in the marked position.

Trim the flap on the clear vinyl strike jamb

seal to clear the bottom door rail.

Cut the drip rail [L] to the length of the

bottom rail plus 1 1/4". Clean the inside edge of the

bottom door rail and the flat side of the drip rail

thoroughly to ensure proper adhesion of the double

stick tape [M]. Unroll the tape and carefully attach it

to the back of the drip rail (do not peel the tape backing

yet). Insert the tapered drip vinyl [N] into the drip rail.

Position the drip rail flush with the bottom of the door

panel, 1/16" from the hinge jamb, then raise the strike

side until the bottom edge of the drip vinyl is parallel

to the curb [A]. Mark the location of each end of the

drip rail with a pencil.

NOTE: Cleaners with alcohol content can dissolve

the adhesive that attaches the drip rail. To prevent

this possibility, place a small bead of clear sealant at

the top of the drip rail where it is attached to the

bottom rail.