Manual

EPH-N00-06007

10-21-04

Page 4 of 8

Unroll the double-stick tape [B] and carefully press

the sticky side onto the flat surfaces on the bottom of the

curb [A]. Remove the protective covering from the tape

and very carefully replace the curb on the shower sill in

the exact position marked in Step #2.

OPTION: Place a bead of caulk on both flat surfaces on

the bottom of the curb. Then replace the curb on the

shower sill between the pencil marks and press firmly

into place.

NOTE: The 338 unit may be installed without using

the sloped curb [A] provided. Its use is definitely recom-

mended for positive water control on shower sills with

little or no slope.

Measure the wall-to-wall opening at the shower sill and

cut the curb to the exact length. File the ends of curb as

necessary to fit the corner contours of the enclosure.

Place the curb on the shower sill with the raised portion

to the exterior of the enclosure. Make sure the curb is

centered on the sill and lightly mark its position on the sill

with a pencil. Remove the curb from the sill.

The A

LUMAX 338 Frameless Pivot Shower Door is

completely reversible and may be installed pivot-right or

pivot-left. Refer to the illustration to determine the

correct position for your installation. For maximum

waterproofing, the pivot jamb should always be opposite

the shower head. These instructions depict a pivot-left

installation.

CAUTION: For safety, the door must always open

outward.

PIVOT

LEFT

PIVOT

RIGHT

MEASURE

SHOWER

SILL

CURB

DOUBLE-STICK

TAPE

CURB