Instruction Manual

Page 3 of 5 EPH-N00-06088

6-3-02

NOTE: Obscure glass doors should be

installed with the rough surface of the glass to the

exterior of the unit. Silk Screened or etched glass

doors should be installed with the patterned surface

to the inside.

Determine which end of the door will be the bottom.

Using a mallet or a hammer and wood block (never

a hammer alone), carefully drive the bottom rail

over the bottom edge of the glass and vinyl, snug

to the factory installed vertical rail. Bottom rail

should be set back from the strike edge of the door.

Trim the excess vinyl even with the ends of the

rails.

Press the hinge jamb/door panel assembly

[*A] and strike jamb [*B] (with magnetic strip)

over the wall jamb and/or framing posts. Refer to

Step #1 of the S

TIKSTALL instruction sheet for the

proper handing of the door.

Adjust the door panel assembly so there is 1/4"

clearance between the strike jamb and the strike

edge of the glass door panel in the closed position.

Mark the location of the hinge jamb on the wall

jamb (or post).

NOTE: The magnetic strip on the strike jamb

must face the exterior and the door panel must

open outward.

Snap both fillers [*C] into the curb and header

between the hinge and strike jambs with the

raised lips to the exterior. Center the curb filler

between the hinge and strike jamb (use masking

tape to hold in position).

NOTE: The snap-in fillers should be exactly 7/16"

longer than the door panel width.