Instruction Manual

EPH-N00-06015

11-24-04

Page 4 of 8

Measure the wall-to-wall opening at the center of

the tub rim. Cut the tub track [A] 1/16" short of this

dimension. An inexpensive miter box (available at your

local hardware store) will help you get clean square cuts.

If the vinyl silencer (X) is separate from the tub track (A)

slide the silencer into the slot in the tub track.

Position the tub track in the center of the tub rim with the

tall leg to the exterior. It may be necessary to file a radius

on the ends of the tub track and wall jambs to match the

corners of the enclosure.

Press both wall jambs [B] into position over the tub track.

Masking tape can be used to hold the parts in place

temporarily.

Use a level to plumb both wall jambs [B],

then mark the pre-drilled hole locations on the

wall. Lightly mark along both sides of the tub

track [A] with a pencil, then remove all parts.

For tile or marble walls, drill six 3/16" diameter

holes and insert the plastic wall anchors [C].

Attachments to fiberglass or acrylic units can be

made in two ways. If a reinforcement is built into

the wall of unit, drill six 1/8" holes to install

mounting screws directly into the reinforcement.

If walls are not reinforced, drill six 3/16" holes and

install plastic wall anchors or toggle bolts (toggle

bolts not supplied by A

LUMAX).

CAUTION: The track should never be screwed to

the tub. This will damage the tub and cause

leakage.

Before replacing the tub track [A], force a

slight downward bow in the extrusion. This will

ensure the track fits tight to the tub. Run two

beads of caulk inside the penciled marks on the

tub rim. Place the tub track in the exact position

marked in Step #2 and seat it firmly in the caulking.

NOTE: Improper caulking will result in leaks.

EXTERIOR