Instruction Manual

Page 5 of 8 EPH-N00-06015

11-24-04

Replace one wall jamb [B] and attach to wall

with two #8 x 1 1/2" truss head screws [D] inserted

through the top and bottom holes. Slip a nylon

spacer [E] over a #8 x 1 1/2" truss head screw and

install in the center hole of the wall jamb. Check

jamb for plumb and tighten screws.

NOTE: Do not overtighten the jamb screws.

NOTE: Obscure glass doors should be

installed with the rough surface of the glass to the

exterior of the unit. Deco or etched glass doors

should be installed with the patterned surface to

the inside.

On doors with obscure or etched glass, there is an

interior and exterior glazed door panel [G] as

determined by the position of the top bearing fin.

Door panels with clear glass are interchangeable.

Attach the four nylon roller bearings [H] to the

door panels as shown, using #8-32 x 3/8" hex head

screws [J] centered in the outside slots in the top

bearing fins.

This bath enclosure is equipped with safety

tee-lock wall jambs. When properly installed, the

header is permanently locked to the wall jambs

and cannot be accidentally dislodged.

Measure the wall-to-wall opening at the top of the

wall jambs [B] and cut the header [F] 1/16" short

of this dimension. Check the header for fit.

Slide the safety tee-lock of the unmounted wall

jamb [B] into the end of the header. The header is

reversible so that either face may be turned to the

exterior of the unit. Holding the header at an

angle, engage the other end onto the mounted wall

jamb. Pivot the header into place, then slide the

loose wall jamb to the wall and press into position

on the tub track. Attach the jamb to the wall per

instructions in Step #4.