Instruction Manual

EPH-N00-06015
11-24-04
Page 6 of 8
9
7
8
Lift the interior panel (with the rough surface
closest to the top fin) into position with the rollers
engaging the roller slot in the header [F].
Repeat for the exterior panel (rough surface away
from the top fin).
If the door panels are not parallel to the wall
jambs, remove them from the header and adjust
the rollers up or down to compensate.
Before finishing the installation it is necessary
to determine the proper closed position of the
doors. For maximum water-proofing, position the
interior panel closest to the shower head, as shown
in the detail.
Slide the four towel bar trim rings [K] over
the clear acrylic towel bar brackets [L] and press
the brackets into the ends of the two towel bars
[M].