Instruction Manual

Page 7 of 8 EPH-N00-06015

11-24-04

Attach a towel bar assembly (with the open

slot in the bar downward) to the interior panel

with a #10-24 x 7/8" truss head screw [N] thru the

inner rail. Insert a #10-24 x 1 1/8" flat head screw

[P] thru an acrylic finger pull [R], thru the outer

rail and into the outer towel bar bracket. Peel the

backing from a A

LUMAX decal [S] press it into the

recess in the acrylic finger pull.

Repeat for the exterior door panel.

NOTE: Do not overtighten the towel bar screws.

Locate the nylon bottom guide [T] in the

middle of the tub track [A] with the door panels in

the position shown. With a 7/64" bit, drill a hole

into the V-groove through the mounting hole in

the bottom guide. Install the bottom guide with a

#6 x 3/8" pan head screw [U] thru the drilled hole.

Slide the stainless steel bumper inserts [V]

into the two soft vinyl jamb bumpers [W]. Align

the slots in the bumpers with the outer rails of the

door panels and snap the bumpers downward over

the center wall jamb screws [D] with the nylon

spacers [E] (see Step #4).