User Manual

Page 5 of 7 EPH-N00-06077

6-3-02

Slide the strike jamb [F] over one of the mounted

wall jambs [B] with the magnet facing outward.

Measure the wall-to-wall opening at the top and at the

bottom of the wall jambs and note the smaller dimension.

Measure the width of the door panel [E] at the bottom rail.

Add 2 1/4" to the door width, subtract the total from the

minimum wall-to-wall opening and divide the result by

two. This should be the distance from the wall to the strike

jamb at the closest point. Plumb the strike jamb vertically

and mark its location on the wall jamb with a pencil.

Inside the shower enclosure, drill two 1/8" holes

thru the strike jamb [F] and into the wall jamb [B] 3/8" to

3/4" from the wall and approximately 1" vertically from

each end of the strike jamb. Drill a third hole centered

between the first two, then enlarge the three outer holes

with a 3/16" drill for clearance on the self-tapping screws.

Attach the strike jamb permanently with three #8 x 1/4"

truss head screws [G].

Slide the door panel [E] over the other wall jamb

[B] until the door panel and the strike jamb [F] can meet.

With the door closed and the latch magnets engaged, the

proper door panel to strike jamb clearance is 1/8" (see

illustration). Mark the hinge jamb’s location on the wall

jamb with a pencil.

Attach the hinge jamb and door panel permanently per the

instructions in Step #5.