User Manual

STEP 5: Gimbal Balancing – Roll Axis

Loosen these 2 Screws. (Hold the Camera at

the same time)

Adjust the Roll Assembly to Left/ Right as to

balance the CG.

Set it to be Parallel before tighten the Screws.

Tighten these 2 Screws. Test if the Roll Axis is balanced well. The Roll

Assembly(with Camera) should always remain

steady in any Angle if it has correct CG.

Test on about 45 degree. Camera should

remain steady if the CG is correct. Repeat the

previous steps to get the correct CG. (Be

Patient Here)