User Manual

Step 3.
Run the GUI Software (2_42b7): SimpleBGC_GUI_2_42b7 → SimpleBGC_GUI(.exe)
Step 1. Run the GUI.exe Software
Step 2. Select the correct COM, then click
Connect
Step 3. If the Connection is successful, you
will see the current firmware. Before start
tuning the gimbal, select the specific Profile
(mean the Mode) and click “Write” button.
As to save your new parameters, always click the “WRTE” button.
Remarks: As to understand the working principle of PID/ other specific tuning, you can refer to the offical manual of the Gimbal Controller:
SimpleBGC_32bit_manual_2_42_eng.pdf
20