Installation guide

ManualsBrandsAmana ManualsDishwasherOfficial Amana dishwasher

BUILT- N DISHWAS

iNSTALLATION iNSTRUCT!ONS

LEAVEINSTALLATIONINSTRUCTIONSAND

USER'S GUIDEWITH OWNER

ALLELECTRICWIRINGAND PLUMBINGMUST BEDONE

IN ACCORDANCEWITH NATIONALAND LOCALCODES.

Summary of content (6 pages)

PAGE 1
BUILT- N DISHWAS iNSTALLATION iNSTRUCT!ONS LEAVEINSTALLATION INSTRUCTIONS AND USER'S GUIDEWITH OWNER ALLELECTRICWIRING AND PLUMBINGMUST BEDONE IN ACCORDANCEWITH NATIONALAND LOCALCODES.
PAGE 2
TOOLS RECKSSAR¥FOR |NSTAL T|ON* SUPPORTACCESSORIES: (2) RATCHET 0 3/4" ULApproved Strain Rdief (proqded) O 3/16", 1/4", 5/16" SOCKETS O 2 Appropriate Sized Wire Nuts O 3/8" Male (NZT.
PAGE 3
WATER VALV O Remove shipping plug from water hflet valve, O Install a 90 ° elbow (3/8" N,P.T) fitting h, to the water valve using Teflon r'_ tape or pipe thread compound. The opposite end of"the fitth*g should fit h_-eoming hot water supply line. Position the end of the elbow towards the rear of the dishwasher IMPORTANT: DO NOT connect a sweat type fitting directly to the water valve as the required beat will damage the water inlet valve. Do not solder within 6" (15.2 era) from the water valve.
PAGE 4
|OR|NG THE DISHWASHER(conUnued) and horizontally. two adjustments are necessary of door m_d latch. Dishwasher to properly position the dishwasher must be LEVEL, solid, m_d square.
PAGE 5
THEF_CTREAL CONNECF|ONS SEE THE ELECTRICAL CAUTION: O Verify power to dishwasher REQUIREMENTS is off at source. n 27- ZZ Remove terminal box covet: Ix order to secure the power supply cable, a UL listed strain relief nmst be used to secure the power supply to the back of tet'mina[ box, Q ....... SECTION Strip approximatdy 3/8" (.09 em) of"insulation fl'om incoming power supply wires. Connect these wires to wires from dishwasher wire ]harness located in the terminal box.
PAGE 6
CAUTION:Disconnect dectricN power before you start! ALL ELECTRICALWIRING AND GROUNDING SHOULD BE DONE IN ACCORDANCE WITH NATIONAL AND LOCAL CODES. This dishwasher operation wired is designed for on an adequately individual 60 Hz approved 120 VAC, electrical circuit. Use required fl_se (15 amp) or comparable circ1_it breaker. Two wire with grolmd service to the dishwasher is recommended for connection at the terminal box and for gro@ding.