Owner`s manual

17
Flashing Display
When power is connected to oven display flashes. Press
OVEN CANCEL to clear display.
Setting Electronic Clock
When power is connected or restored, display flashes
until pad is pressed.
1. Press CLOCK pad.
2. Press
+
or
-
pad until correct time-of-day displays.
• Clock saves time-of-day approximately 5-10
seconds after time is entered.
Setting Electronic Timer
The timer is a timer only. Electronic timer does not control
bake, broil, or self-clean function. Timer can be set up to
11 hours and 50 minutes.
1. Press MINUTE TIMER pad.
2. Press
+
or
-
pad until correct time displays.
• Time increases in larger increments the longer
+
or
-
pad is held.
• Timer begins counting down automatically after
time is entered.
3. Press MINUTE TIMER pad to cancel timer signal.
• After time elapses, timer beeps 3 times, and then
approximately once every 6-8 seconds until
MINUTE TIMER pad is pressed.
Resetting and Canceling Timer
To reset the time when remaining time is displayed, press
MINUTE TIMER pad, then
+
or
-
pad until new time
displays. To cancel timer, press and hold MINUTE TIMER
pad for approximately 5 seconds.
Prepare for Bake, Timed Bake, and Delayed
Bake
CAUTION
!
To reduce risk of food poisoning due to bacterial growth
and production of toxins, never hold meat, milk, fish or
eggs for more than 2 hours before cooking.
Remove Items Stored in Oven
Remove any pans and other cooking utensils stored in
oven.
Remove Items Stored in Oven
Other Features
12-hour
automatic
cancel
This safety feature prevents oven from continuing to operate if it has been left on for over
12 hours. If a cooking function continues longer than 12 hours without any options on oven
control being touched, this feature turns oven off. Any time an option is touched, 12-hour
automatic cancel is reset.
Child lockout
This safety feature is used to prevent children from accidentally programming oven by
disabling electronic oven control. Press and hold BAKE and COOK TIME for 5 seconds.
“OFF” displays where the temperature normally appears. To reactivate control, press and
hold BAKE and COOK TIME pads for 5 seconds on the upper oven control. Child lockout
must be reset after a power failure.
Service codes
and tones
Electronic oven control is equipped with a self diagnostic system. Self diagnostic system
alerts you if there is a error or problem in the control. If electronic range control sounds a
series of short, rapid beeps for over 16 seconds and display shows a F-code, record the F-
code shown. Some F-codes can be cleared by touching OVEN CANCEL or disconnecting
power to the range. If the code continues to reoccur call an authorized servicer. Disconnect
electrical supply to range and contact an authorized servicer.