Owner`s manual

27
Removing Oven Door
CAUTION
!
To avoid personal injury or property damage, handle
oven door with care.
• Door is heavy and can be damaged if dropped.
• Avoid placing hands in hinge area when door is
removed. Hinge can snap closed and pinch hands.
• Do not scratch or chip glass, or twist door.
Glass may break suddenly.
• Replace door glass if damaged.
• Do not lift door by handle.
1. Open door fully.
2. Remove screws.
• Oven doors are attached with a screw on each side
of lower oven door.
3. Close door to first stop, grasp door firmly on each
side, and lift upward until door is off hinges.
• Do not lift door by handle. Glass can break.
• Only push hinges closed once oven door is
removed if necessary. Use both hands when
closing hinge. Hinge snaps closed.
Removing Oven Door
Removing Storage Drawer
1. Slide drawer out until it stops.
2. Grasp drawer sides near back of drawer.
3. Lift up and out. Reverse to reinstall.
Removing Storage Drawer
Care and Cleaning
Replacing Oven Light
WARNING
!
To avoid risk of burns or electrical shock, disconnect
electrical supply to oven before changing light bulb.
• Before replacing light bulb make sure bulb is cool.
• Do not operate oven without bulb and cover in place.
CAUTION
!
Wear gloves to protect hands from accidental bulb
breakage.
1. Disconnect electrical supply.
2. Remove oven door if desired.
3. Unscrew light bulb cover located in rear of oven
cavity. Then turn light bulb counterclockwise to
remove.
4. Replace light bulb with 120-volt, 40-watt appliance
bulb.
• Do not overtighten bulb or it may be difficult to
remove later.
5. Replace light bulb cover and oven door before use.
6. Reconnect power supply.
Replacing Oven Light Bulb
Replacing Fluorescent Backguard Light
Bulb
1. Disconnect electrical supply. Wear protective gloves.
2. Grasp ends of top backguard cover firmly and flip it
upward and open.
3. Hold fluorescent bulb using both hands and carefully
rotate it upward toward back of range. Lift bulb out.
4. Slide pins on both ends of new bulb into lamp holder
slots. Push down slightly and rotate bulb toward front
of range until it clicks into socket. Close top
backguard cover.