Master Catalog
MC-DPTAC www.amana-ptac.com 11
accessories (conT.)
230/208V 15A
FHK315E
230/208V 15A (R-410A)
230/208V 20A
FHK320E
230/208V 20A (R-410A)
230/208V 30A
FHK330E
230/208V 30A (R-410A)
fuse holder Kit
Cartridge-style fuses can be installed in the fuse holder for use in the sub-base or
chassis. Available in 15, 20 and 30 amp (included on 265-volt unit).
CirCuit breaKer Kit (230/208V only)
The circuit breaker kit, available in 15, 20 or 30 amp, can be used with Amana
brand sub-bases. It gives overcurrent protection, and its location allows you to
turn the unit on or off without tools.
Basepan
Condenser
Condenser Baffles
Condenser baffle Kit
For use on non-bafed grilles. These deectors direct the air in toward the
center and away from the inlet to prevent recirculation of the hot condenser air.
230/208V
265V
poWer disConneCt sWitCh
The PSHW**A power disconnect switch can be used for 265-volt or 230/208-volt
physical disconnect, where required by local codes. The switch is rated at 30-
amp capacity. The switch is for use with and Amana® brand standard sub-bases
or PTPWHWK4 Hard Wire Kit.
Main Duct – R-22
Main Duct – R-410A
Extension Duct
duCt extension Kit
Extends air distribution to an adjoining room. Consists of a main duct for the room
of origin and an extension duct to reach the adjoining room and terminal duct.
PTDK01A allows for the new “B” series unit to work with the “A” series duct kits.
TRANSITION BAFFLES
Terminal Duct
230/208V – R-22
265V – R-22
230/208V – R-410A
265V – R-410A
poWer Vent Kit
Installation of Power Vent increases CFM up to approximately 95. Vent door will
automatically close when unit fan is off.
230/208V – R-22
265V – R-22
230/208V – R-410A
Condensate reMoVal puMp
Can be eld-installed. Assists in removing condensate developed by heat pump
operation and transfers it to indoor coil to dissipate into room while adding
humidity to the room.
sub-base extension CoVer Kit
Converts older 30-amp sub-bases to allow for installation of the larger 30-amp
LCDI power cord and plugs.
SBEC10A