User manual

Page 2
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL [phone]  FAX [phone]
www.AmbientWeather.com
3. Connect the WeatherHub3 to your router or switch.
Note: a cabled connection is required to configure the
device. It can later be disconnected after the wireless
LAN is configured.
4. Connect the AC power adaptor to the WeatherHub3. The
unit will turn on and the blue status light on the front of the
WeatherHub3 will turn solid on after approximately one
minute.
Figure 1
4 IP Addressing
The WeatherHub3 is programmed from the factory for dynamic
addressing (or DHCP). This allows to you to address the unit from
any computer on your network without modifying the IP address.
However, since it is dynamic, you will have to determine the
address that was assigned to the unit.
To determine this address, load and install the IPScan tool
provided on the CD. You can also download it here:
http://www.download25.com/install/free-ip-scanner.html
For Mac and Linux users, visit:
http://www.angryip.org/w/Download
Select the Start Scanning button. After the scan is complete,
locate the IP address associated with the Host Name
METEOPLUG (or METEOHUB). In the example figure below, the
IP address was assigned to 192.168.1.77.
Figure 2