User manual

the relative pressure is 30.00 inHg (1016 mb).

The standard sea-level pressure is 29.92 in Hg (1013 mb). This is the average sea-level pressure

around the world. Relative pressure measurements greater than 29.92 inHg (1013 mb) are

considered high pressure and relative pressure measurements less than 29.92 inHg are considered low

pressure.

To determine the relative pressure for your location, locate an official reporting station near you (the

internet is the best source for real time barometer conditions, such as Weather.com or

Wunderground.com), and set your weather station to match the official reporting station.

To change the relative pressure in SET mode, press the + key or MIN/MAX key to increase or

decrease the relative pressure setting to match the official reporting station.

4.3 Alarm Mode

4.3.1 Alarm Display

While in Normal Mode, press the ALARM key to enter the High Alarm Mode. Press the ALARM

key again to enter the Low Alarm Mode. Press the ALARM key again to return to normal mode (or

wait 10 seconds).

Note: After entering the ALARM mode, the console will display the high and low alarm

settings. If the value reads --.-- (dashes), the alarm is not active.

4.3.2 Alarm Programming

While in Alarm Mode, press the SET key to set the alarms. The following are high and low alarms:

High Alarm Limits:

 Time alarm (hour/minute)

 Indoor humidity high alarm

 Indoor temperature high alarm

 Outdoor humidity high alarm

 Outdoor temperature / dew point high alarm

 Pressure high alarm

Low Alarm Limits:

 In the Low Alarm Mode press the SET key to select the following alarm modes:

 Time alarm (hour/minute)

 Indoor humidity low alarm

 Indoor temperature low alarm

 Outdoor humidity low alarm

 Outdoor temperature / dew point low alarm

 Pressure low alarm

In the alarm mode, Press the + key or MIN/MAX key to change or scroll the alarm value while the

specific alarm is flashing.

Hold the + key or MIN/MAX key for 3 seconds to change the number rapidly. Press the ALARM key

to select the alarm on or off (if alarm is enabled, the speaker icon on the LCD will be turned on