User manual

4 Display Console Set Up

Move the remote sensor(s) about 5 to 10’ away from the display console (if the sensor is too close, it

may not be received by the display console).

If you have more than one remote sensor, make sure they are all powered up and transmitting on

different channels. Remove the battery door on the back of the display, as shown in Figure 5.

Figure 5

Fold out the desk stand, remove the battery cover, and insert three AAA (alkaline or lithium, avoid

rechargeable unless fully charged and high quality) batteries in the back of the display console. All

of the LCD segments will light up for a few seconds (to verify all segments are operating properly).

1. Replace the battery door, and place the console in the upright position with the desk stand

folded out.

The console will instantly display time and indoor temperature as designated. The remote

temperature will update on the display within a few minutes on the appropriate channel.

While in the search mode, the remote search icon will be constantly displayed.

If you have more than once remote sensor (up to eight remotes are supported), the display

will automatically toggle between sensors until all sensors have reported in.

Do not touch any buttons until the remote sensor has reported in, or the radio search icon