User's Manual

DIP SWITCH

1 2 3 4

FUNCTION

DOWN DOWN DOWN --- Channel 1

DOWN DOWN UP --- Channel 2

DOWN UP DOWN --- Channel 3

DOWN UP UP --- Channel 4

UP DOWN DOWN --- Channel 5

UP DOWN UP --- Channel 6

UP UP DOWN --- Channel 7

UP UP UP --- Channel 8

--- --- --- DOWN °F

--- --- --- UP °C

Table 1

5. Insert two AAA batteries.

6. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and

then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting

data.

7. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are

on the display, as shown in Figure 3.

Figure 3

(1)

temperature

(2) temperature units (

°F vs. °C)

(3) channel number

8. Close the battery door. Make sure the gasket (around the battery compartment) is properly

seated in its trace prior to closing the door. Tighten the set screw.