User's Manual

Table Of Contents

To attach the suction cup to the remote sensor, reference Figure 7 .

1. Locate the mounting hole on the back of the unit.

2. Press the suction cup into the mounting hole.

3. While applying pressure with your thumb, twist the suction cup until

fully inserted.

4. Wet the back of the suction cup and apply to clean, smooth, flat

surface.

Figure 7

Note: Both sensors have the capability of being placed inside or outside

the refrigerator/freezer, but it is recommended you install it outside. This will

extend the battery life, the sensor life, and improve wireless communication

range.

Note: Make sure that the refrigerator surface is smooth and clean,

so that suction cups will not fall off. It is recommended to wet the surface

of the suction cup first to improve the seal.