HIGH WALL SPLIT AIR CONDITIONER User manual AHW 164

CLEANING

Turn the appliance off and disconnect the power.

Interior unit

Check that the condensation outlet drains properly.

Dust regularly with a dry cloth or slightly damp paper towel.

Never use chemicals or solvents. Never spray a liquid in or over the appliance.

Exterior unit

Remove dirt and keep the air intake and exhaust openings free of leaves, etc.

Cleaning with chemicals may cause damage.

If the air conditioner is not going to be used for an extended period:

• set in fan mode with temperature set at 86°F (30°C)

for about half a day so that the inside will dry

completely

• stop the operation, switch off the power supply and

take the batteries out the remote control

• clean the inside and outside unit

• clean the filters as well.

END OF PERIOD OF USE

If the air conditioner is to be used again after an extended period:

• check that the air intake and exhaust openings of the

interior and exterior units are not blocked. Remove all

dirt and obstacles.

• check that there is a clean filter in the interior unit.

• check that the condensation outlet of the interior unit drains properly.

• install 2 AAA batteries in the remote control.

• clean the interior unit.

• connect to the power source, turn the appliance on, set the time and

desired setting.

Note: make sure condensation is drained freely and that there is no obstacle

such as algae growth, otherwise leaks may occur.

START OF PERIOD OF USE