HIGH WALL SPLIT AIR CONDITIONER User manual AHW 164

6
OPERATION
General
• Turn the appliance on with the ON/OFF button . This activates the most
recent setting.
• The
ON/OFF button turns the appliance off; the type of operation set at
that time is stored in the memory.
• The MODE button cycles through the various modes in this order: auto ,
cool , dehumidify , fan .
• The desired temperature is set with the up and/or down -button,
within the limits of the thermostat: 64 °F – 86 °F (18 °C – 30 °C). Each time
the -button is pressed, the set temperature increases with 1 °F (or 1 °C);
similarly when the -button is pressed, the set temperature decreases
with 1 °F (or 1 °C).
• Use the FAN SPEED button to set the fan speed at low: , medium: , high:
or automatic: . The fan speed in the automatic setting is determined
by the difference between the set temperature and the room temperature.
Setting the time
The current time must be set after initial installation and at the start of a new
period of use. With batteries (new, if necessary) in the remote control:
Press the CLK-button in the battery compartment with the
tip of a pencil. The time indicator will flash. First use the
HOUR button to set the hours, then the MIN button to set the
minutes. Press the CLK-button again.
The time is used for the timer function, so accurate setting of
the current time is important.
Auto mode
1. Press the MODE button until the auto mode symbol appears.
2. The difference between set temperature and room
temperature determines how the appliance will operate:
cool, dehumidify or fan. The up and down buttons
for temperature setting will not work, set the desired
temperature before activating auto mode.
3. Use the FAN SPEED button to set the fan speed.
Cool
1. Press the MODE button until the cool symbol appears.
2. Set the desired temperature with the up and/or down
-button.
3. Use the
FAN SPEED button to set the fan speed.