HIGH WALL SPLIT AIR CONDITIONER User manual AHW 164

9
FILTERS
To open: at the A recesses, pull the
front part up. The front part will stay
horizontal (turn up 60 °).
To close: press the front part down at
the sides at B and in the middle at C.
Make sure it is properly closed (click).
1. Hold the front part open (or put it in horizontal position) and remove the
filter(s).
2. A dirty filter reduces the capacity. Clean the filter gently, use a vacuum
cleaner to remove dirt. If the dust filter is very dirty, it may be washed in
lukewarm water with a very small amount of neutral detergent. Rinse well
and allow to dry completely (not in direct sunlight or near a source of heat).
3. Keep the grid panel open and reinstall the filter(s). Press the panel shut; a
click indicates it is closed properly.
4. Reconnect the power and turn the air conditioner on.
Turn the appliance off and disconnect the power.
A
A
C
B
B
Emergency start
In the event of a problem or missing remote control, the air
conditioner can be operated using the emergency button
under the panel in the interior unit. Open the front panel
and press the button to switch on (in the mode last set) or
to switch off.